ISOLATION OF BUCCAL CELL DNA

©David B. Fankhauser, Ph.D.
Professor of Biology and Chemistry
University of Cincinnati Clermont College,
Batavia OH 45103
pelleted buccal cells
spun down from saline
modified from the protocol of Sonia Wallman

This page has been accessed Counter times since 13 February 2003. 
19 January 2001, 13 Feb 01, 3 Jan 03
chelex treated cells
100 C for ten minutes

This procedure is used to isolate individual DNA to be used in future PCR probes.  Completely non-invasive and straight forward, it is a simple method to isolate small amounts of DNA from buccal cells.
 
 

EQUIPMENT:
15 mL sterile polypropylene test tube
two sterile 1.5ml Eppendorf tube
5mL pipettor + sterile tips
1000 uL micropipettor + sterile tips
200 uL micropipettor + sterile tips
clinical centrifuge, balance
1.5 mL test tube holder (> 10 holes) 
boiling water bath in 1000 mL beaker
microcentrifuge		 SUPPLIES PER STUDENT:

10 mL 0.9% saline
0.5 mL 10 % Chelex resin beads in sterile dH2O
 
 
 
 

 

 
HARVEST BUCCAL CELLS:
Label a 15 mL polypropylene test tube and the top of a 1.5ml Eppendorf tube with your name and/or seat number. 

Pipet 10 mL of 0.9% saline into the test tube, using 5 mL pipettor. 
Pour the 10 mL of saline solution into your mouth and vigorously swish against your cheeks for 10 seconds. 

Expel saline solution back into the labeled 15 mL polypropylene test tube over the sink. (A funnel makes for a cleaner transfer...)
SPIN DOWN CELLS
Place your test tube, with others, in a balanced array in the clinical centrifuge.  Centrifuge at 2000 x g for 10 minutes. (Top speed, setting number 7 on the tabletop clinical centrifuge.)
The cells form a firm pellet below the saline supernatant.
SAVE THE PELLET, DISCARD THE SUPERNATANT by decanting into the sink with running water, taking care not to disturb pelleted cheek cells at the bottom of the tube. 
Drain all of the saline supernatant.
ADD CHELEX BEADS: Use micropipettor to resuspend the 10% suspension of Chelex resin beads, by pipetting the beads in and out of the micropipettor. Before resin settles, pipet 500 uL of Chelex into the 15 mL tube containing your buccal cell pellet. Save pipet tip.
RESUSPEND CHEEK CELLS WITH CHELEX by pipetting in and out several times. (If the tip stops up, snip off 2 mm of the tip to enlarge the aperture.)
Examine the suspension carefully to ensure that no visible clumps remain. 
Transfer a 500 uL aliquot of the cells and resin suspension to a clean 1.5 mL Eppendorf tube labeled with your name. 
BOIL FOR 10 MINUTES: Place your sample, along with others, into a 1.5 mL floating test tube holder and place in a boiling water bath for 10 min. 
Time the ten minutes in the boiling water bath.
CHILL ON ICE: AFter the heat treatment, transfer all samples to crushed ice. 
SPIN DOWN CHELEX: Place your chilled sample, along with others, in a balanced array in a microcentrifuge and spin for 30 to 60 seconds at top speed.
The chelex precipitates along with the denatured protein.  The DNA is in the supernatant.
SAVE 200 L CLEAR SUPERNATANT: Use a fresh pipet tip to transfer 200 uL of the clear supernatant to a clean 1.5 mL Eppendorf tube labeled with your name, date, and "cheek DNA." 

Take care not to pick up any of the cheek cell debris or resin from the bottom of the tube. 
Store your sample for a few minutes or hours on crushed ice or for days at -20 degrees Centigrade until you are ready to proceed to Set up and run PCR reaction.

Created using Thotor - Photo Thumbnail Generator!